Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 835)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 811
53-1003031-02
Displaying 6PE information
9
Outbound Policy
Group Shows the ID and the count used in the outbound policy group.
BFD Shows whether or not Bidirectional Forwarding Detection (BFD) is enabled on the device.
TCP Connection
state Shows the state of the connection with the neighbor. The connection can have one of the
following states:
•
LISTEN – Waiting for a connection request.
•
SYN-SENT – Waiting for a matching connection request after having sent a connection
request.
•
SYN-RECEIVED – Waiting for a confirming connection request acknowledgment after
having both received and sent a connection request.
•
ESTABLISHED – Data can be sent and received over the connection. This is the normal
operational state of the connection.
•
FIN-WAIT-1 – Waiting for a connection termination request from the remote TCP, or an
acknowledgment of the connection termination request previously sent.
•
FIN-WAIT-2 – Waiting for a connection termination request from the remote TCP.
•
CLOSE-WAIT – Waiting for a connection termination request from the local user.
•
CLOSING – Waiting for a connection termination request acknowledgment from the
remote TCP.
•
LAST-ACK – Waiting for an acknowledgment of the connection termination request
previously sent to the remote TCP (which includes an acknowledgment of its connection
termination request).
•
TIME-WAIT – Waiting for the specific time to ensure that the remote TCP received the
acknowledgment of its connection termination request.
•
CLOSED – There is no connection state.
Maximum
segment size Shows the TCP maximum segment size.
TTL check Shows the TCP TTL check.
Byte Sent Shows the number of bytes sent.
Byte Received Shows the number of bytes received.
Local host Shows the IPv4 address of the router.
Local port Shows the TCP port that the router is using for the BGP4 TCP session with the neighbor.
Remote host Shows the IPv4 address of the neighbor.
Remote port Shows the TCP port that the neighbor is using for the BGP4 TCP session with the router.
ISentSeq Shows the initial send sequence number for the session.
SendNext Shows the next sequence number to be sent.
TotUnAck Shows the count of the sequence numbers sent by the router that have not been
acknowledged by the neighbor.
TotSent Shows the count of the sequence numbers sent to the neighbor.
ReTrans Shows the count of the sequence numbers that the router retransmitted because they were
not acknowledged.
UnAckSeq Shows the current acknowledged sequence number.
IRcvSeq Shows the initial receive sequence number for the session.
RcvNext Shows the next sequence number expected from the neighbor.
SendWnd Shows the size of the send window.
TABLE 156 Output parameters of the show ip bgp 6pe neighbors command (Continued)
Field Description