Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 716)

692 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying additional BGP or MPLS VPN information
6
Displaying additional BGP or MPLS VPN information
The user can display the following additional information about a BGP or MPLS configuration on the
device:
• “Displaying IP network information for a VRF”
• “Displaying the IP route table for a specified VRF”
• “Displaying ARP VRF information”
• “Displaying OSPF information for a VRF”
• “Displaying OSPF area information for a VRF”
• “Displaying OSPF ABR and ASBR information for a VRF”
• “Displaying general OSPF configuration information for a VRF”
• “Displaying OSPF external link state information for a VRF”
• “Displaying OSPF interface information”
• “Displaying OSPF neighbor information for a VRF”
• “Displaying the routes that have been redistributed into OSPF”
• “Displaying OSPF route information for a VRF”
Origin The source of the route information. The origin can be one of the following:
•
EGP – The routes with this set of attributes came to BGP through EGP.
•
IGP – The routes with this set of attributes came to BGP through IGP.
•
INCOMPLETE – The routes came from an origin other than one of the above. For
example, they may have been redistributed from OSPF or RIP.
When BGP4 compares multiple routes to a destination to select the best route, IGP is
preferred over EGP and both are preferred over INCOMPLETE.
Atomic Whether network information in this route has been aggregated and this aggregation
has resulted in information loss.
NOTE: Information loss under these circumstances is a normal part of BGP4 and
does not indicate an error.
Aggregation ID The router that originated this aggregator.
Aggregation AS The AS in which the network information was aggregated. This value applies only to
aggregated routes and is otherwise 0.
Originator The originator of the route in a route reflector environment.
Cluster List The route-reflector clusters through which this route has passed.
Learned From The IP address of the neighbor from which the Brocade device learned the route.
Admin Distance The administrative distance of the route.
Adj_RIB_out The number of neighbors to which the route has been or is advertised. This is the
number of times the route has been selected as the best route and placed in the
Adj-RIB-Out (outbound queue) for a BGP4 neighbor.
Communities The communities the route is in.
Extended Community The extended communities the route is in.
TABLE 130 BGP VPNv4 route information (Continued)
This field... Displays...