Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 264)

240 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying the Traffic Engineering database
1
Syntax: show mpls lsp [detail / lsp_name]
The lsp_name variable specifies the name of the LSP the user wants to display.
Table 23 describes the output from the show mpls lsp detail command.
TABLE 23 Output from the show mpls lsp detail command
This field... Displays...
Name The name of the LSP. LSPs are displayed in alphabetical order.
To The egress LER for the LSP.
From The LSPs source address, configured with the from command. When a source IP address
has not been specified for the LSP with the from command, and the LSP has not been
enabled, then “(n/a)” is displayed in the From field.
admin The administrative state of the LSP. Once the user activates the LSP with the enable
command, the administrative state changes from DOWN to UP.
status The operational state of the LSP. This field indicates whether the LSP has been established
through signaling and is capable of having packets forwarded through it. When the status
of the LSP is DOWN, the reason why the LSP is down is shown in parentheses.
There may be a short period of time after the user enables the LSP that the administrative
state of the LSP is UP, but the status is DOWN. Once the LSP has been established through
signaling, both the administrative state and the status is UP.
Path selected The path currently selected for this LSP.
mode The path selection mode currently configured for the LSP. It can be one of the following:
•
auto
•
manual
•
unconditional
revert-timer The time in seconds for which the revert-timer has been configured.
Path selected is... The current status of the selected path. During a transition period, this message describes
the number of seconds that the path has been up in the latest instance and the number of
seconds before traffic is switched.
Times primary LSP
goes up The number of times the status of the LSP's primary path has transitioned from DOWN to
UP.
Metric The metric for the LSP, configured with the metric command.
no. of installed
aliases The number of aliases that have been installed for the egress LER.
Max retries The maximum number of attempts the ingress LER attempts to connect to the egress LER,
set with the retry-limit command.
no. of retries The number of attempts the ingress LER has made to connect to the egress LER.
Pri. path The name of the primary path for this LSP and whether the path is currently active.
Sec. path The name of the secondary path for this LSP and whether the path is currently active.
Hot-standby Whether the secondary path is a hot-standby path.
status The operational state of the secondary path.
Setup priority The configured setup priority for the LSP.
hold priority The configured hold priority for the LSP.
ipmtu The maximum packet size in bytes for IP packets transiting the LSP without being
fragmented.