Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 761)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 737
53-1003031-02
show cam ifl slot/port
6
show cam ifl slot/port
The output of show cam ifl slot/port is modified to add IFL-ID in the display.
Syntax show cam ifl slot/port
Parameters slot/port
The slot/port parameter specifies the port for which you want to display the CAM entries.
Modes Privileged EXEC mode.
Command
output
Output field Description
Slot Slot-number
Index (Hex) Shows the row number of this entry in the IP route table.
Port Port-number
Outer VLAN Shows path
Inner VLAN Shows channel
PRAM (Hex) Shows the ACL PRAM entries.
IFL ID Same as VPN-ID in IPVPN CAM
IPv4/v6 Routing Shows whether IPv4 or IPv6 is enabled or disabled on the interface.
Example
Brocade(config)#show cam ifl 1/1
Slot Index Port Outer VLAN Inner VLAN PRAM IFL ID IPV4/V6
(Hex) (Hex) Routing
4 0061ffd 1/2 1 0 001ffd 4097 0/0
4 0061fff 1/1 1 0 001fff 4097 1/0
To add VRF to VE.
Brocade(config)# vlan 22
Brocade(config-vlan-22)# tagged ethe 1/7
Brocade(config-vlan-22)# router-interface ve 22
Brocade(config-vlan-22)# exit
Brocade(config)# interface ve 22
Brocade(config-vrf-22)# vrf forwarding blue
Brocade(config-vrf-22)# ip address 10.0.0.22/24
Brocade(config-vrf-22)# exit
Brocade(config)# show cam ifl 1/7
Slot Index Port Outer VLAN Inner VLAN PRAM IFL ID IPV4/V6
(Hex) (Hex) Routing
1 0061fff 1/7 22 0 001fff 4097 1/0