Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 202)

178 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Dynamic Bypass LSPs
1
Enabling the record route option
An interface level record route parameter can be configured for a dynamic bypass LSP
corresponding to a protected link. Use the record command to enable or disable the dynamic
bypass LSP record route options. Based on the value of this parameter, dynamic bypass LSPs are
created with their record route option enabled or disabled.
Brocade(config-mpls-if-e100-2/3-dynamic-bypass)# record
Brocade(config-mpls-if-e100-2/3-dynamic-bypass)#
Syntax: [no] record
Use the [no] form of the command to disable the record route option. The interface dynamic bypass
configuration shows ‘no record’.
Configuring non-adaptive LSPs
Dynamic Bypass LSPs are by default, adaptive in nature. There is a provision to create a dynamic
bypass LSP with non-adaptive nature. When configured as no adaptive, this reflects on interface
configuration as ‘no adaptive’ and any dynamic bypass LSP which is created further is
non-adaptive by default. To re-enable the adaptive nature, use the adaptive command. Based on
the value of this parameter, the dynamic bypass LSPs is created as an adaptive bypass LSP or
non-adaptive bypass LSP.
Brocade(config-mpls-if-e100-2/3-dynamic-bypass)# no adaptive
Brocade(config-mpls-if-e100-2/3-dynamic-bypass)#
Use the [no] form of the command to disable the adaptive parameter. All of the dynamic bypasses
to be created are non-adaptive. The interface dynamic bypass configuration shows ‘no adaptive’.
Configuring administrative groups
Use the interface level exclude-any |include-all | include-any command to configure administrative
groups for dynamic bypass LSPs to be created corresponding to a protected link.
Brocade(config-mpls-if-e100-2/3-dynamic-bypass)# include-all 4 5
Brocade(config-mpls-if-e100-2/3-dynamic-bypass)#
Syntax: [no] include-all | include-any | exclude-any group-no or name
Use the group-no or name parameter for the following:
• include-all group-no or name: include all type admin group number or group name.
• include-any group-no or name: include any type admin group number or name.
• exclude-any group-no or name: include any type admin group number or name.
Group number value ranges for all three types are 0-31. The default value is no admin group
configured for all three types.
Use the [no] form of the command to return the settings to the default value.