Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 781)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 757
53-1003031-02
ACL Support for VE over VPLS
7
The num parameter lets the user display the table beginning with a specific entry number.
The entry numbers in the ARP cache are not related to the entry numbers for static ARP table
entries.
Show ip static-arp
Use the show ip static-arp command to display port, VPLS-ID, VLAN, and VPLS peer information.
Brocade(config)# show ip static-arp
Total no. of entries: 2
Index IP Address MAC Address Port/VLAN ESI Vpls-Vlan:Port/Vpls-Peer
1 10.10.10.10 0000.0033.4444 100
2 10.11.11.11 0000.0066.7777 4/1
3 10.12.12.12 0000.0023.4343 *:21:3/2
4 10.26.5.12 0000.00F3.4343 *:1.2.3.105
Syntax: show ip static-arp [ethernet slot/portnum | mac-address xxxx.xxxx.xxxx [mask] | ip-addr
[ip-mask]] [num] [| begin expression | exclude expression | include expression]
Show mpls vpls id
Use the show mpls vpls command to display VPLS information.
Brocade# show mpls vpls id 2
VPLS b, Id 2, Max mac entries: 100000
Routing Interface Id 3
Total vlans: 1, Tagged ports: 1 (1 Up), Untagged ports 0 (0 Up)
IFL-ID: n/a
Vlan 444
Tagged: ethe 4/5 ethe 4/5
VC-Mode: Raw
CPU-Protection: ON, MVID: 0x005, VPLS FIDs: 0x0000a00a, 0x0000a00a
Local Switching: Enabled
Extended Counter: ON
Mutlicast Snooping: Disabled
Syntax: show mpls vpls id vpls-id
Syntax: show mpls vpls name vpls-name
The vpls-id variable is the ID of a VPLS instance. The vpls-name variable is the name of a VPLS
instance.
Show ip interface ve
Brocade # show ip int