Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual
Page 106
Brocade# show mpls bypass-lsp name test
LSP test, to 10.100.100.100
From: 10.7.7.1, admin: UP, status: UP, tunnel interface(primary path):
tnl3
Times primary LSP goes up since enabled: 1
Metric: 0, number of installed aliases: 0
Maximum retries: NONE, no. of retries: 0
Pri. path: new, up: yes, active: yes
Setup priority: 7, hold priority: 0
Max rate: 0 kbps, mean rate: 0 kbps, max burst: 0 bytes
Constraint-based routing enabled: yes
Path calculated using constraint-based routing: yes
Path calculated using interface constraint: no
Tie breaking: random, hop limit: 0
LDP tunneling enabled: no
Active Path attributes:
Tunnel interface: tnl3, outbound interface: e4/7
Tunnel index: 4, Tunnel instance: 1 outbound label: 5908
Explicit path hop count: 3
10.8.3.1 (S) -> 10.9.11.1 (S) -> 10.1.1.2 (S)
Recorded routes:
Protection codes: P: Local N: Node B: Bandwidth I: InUse
10.8.3.1 -> 10.9.11.1 -> 10.1.1.2
Fast Reroute: facility backup desired
Backup LSP: UP, out-label: 3, outbound interface: e4/18 bypass_lsp:
bkp-2
Path cspf-group computation-mode: add-penalty
FRR Forwarding State: Pri(active), Backup(up)
82
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
MPLS CSPF fate-sharing group
1
Syntax: show mpls bypass-lsp name lsp_name