Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 668)

644 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying BGP or MPLS VPNv4 information
6
Displaying VPNv4 dampened paths information
To view BGP VPNv4 paths suppressed due to dampening, enter the following command.
Brocade# show ip bgp vpnv4 dampened-paths
Displaying VPNv4 filtered routes information
To view BGP VPNv4 filtered paths information, enter the following command.
Brocade# show ip bgp vpnv4 filtered-routes
Displaying VPNv4 Flap statistics information
To display route flap statistics for all routes, enter the following command at any level of the CLI.
Brocade# show ip bgp vpnv4 flap-statistics ?
Syntax: show ip bgp vpnv4 flap-statistics [regular-expression regular-expression | address / mask
[longer-prefixes] | neighbor ip-addr | filter-list num...]
Cluster List The route-reflector clusters through which this set of attributes has
passed.
Aggregator Aggregator information:
•
AS Number shows the AS in which the network information in the
attribute set was aggregated. This value applies only to
aggregated routes and is otherwise 0.
Router-ID shows the device that originated this aggregator
Atomic Whether the network information in this set of attributes has been
aggregated and this aggregation has resulted in information loss.
•
TRUE – Indicates information loss has occurred
•
FALSE – Indicates no information loss has occurred
NOTE: Information loss under these circumstances is a normal part of
BGP4 and does not indicate an error.
Local Pref The degree of preference for routes that use this set of attributes
relative to other routes in the local AS.
Communities The communities that routes with this set of attributes are in.
Extended Community The extended community attributes.
AS Path The ASs through which routes with this set of attributes have passed.
The local AS is shown in parentheses.
Address This is an internal value used for debugging purposes only.
Hash This is an internal value used for debugging purposes only.
Reference Counts This is an internal value used for debugging purposes only.
TABLE 111 BGP VPNv4 attribute entries (Continued)
This field... Displays...