Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 821)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 797
53-1003031-02
show mpls vpls detail
8
show mpls vpls detail
VPLS Manual LSP assignment for a peer can now accept maximum of eight LSPs instead of four
LSPs.
The show mpls vpls detail command output shows all the tunnels (max eight) used.
Syntax show mpls vpls detail
Parameters None
Modes Global configuration mode.
Command
output
The show mpls vpls detail command displays the following information.
Output field Description
VPLS The configured name of the VPLS instance.
ID Max mac entries The ID of this VPLS instance.
Total vlans The number of VLANs that are translated for this VPLS instance.
Tagged ports The total number of tagged ports that are associated with VLANs in this VPLS instance,
as well as the number of these ports that are up.
Untagged ports The total number of untagged ports that are associated with VLANs in this VPLS
instance, as well as the number of these ports that are up.
IFL-ID The Internal Forwarding Lookup Identifier (IFL-ID) for dual-tagged ports in the VPLS
instance.
VC-Mode The VC mode for the VPLS instance:
• Raw – The VLAN tag information in the original payload is not carried across the MPLS
cloud
• Tagged – The VLAN tag information in the original payload is carried across the MPLS
cloud
• Raw-pass-through -The VLAN tag information behaves like tagged mode when all
endpoints are configured as tagged endpoints
CPU-Protection Whether CPU protection configured on this VPLS instance is ON or OFF. On Brocade
NetIron XMR and Brocade MLX series devices only: When CPU protection is enabled on
this VPLS instance but is temporarily unavailable due to 100% multicast FID usage, this
field includes the message shown above.
Local Switching Whether local switching behavior on a per-VPLS basis is enabled or disabled.
Extended Counter Indicates whether or not the extended counter is enabled for the
configured VPLS.
Multicast Snooping Indicates whether the multicast snooping is enabled or disabled.
Examples
Brocade# show mpls vpls detail
VPLS v2, Id 200, Max mac entries: 2048
Total vlans: 2, Tagged ports: 2 (2 Up), Untagged ports 0 (0 Up)
IFL-ID: n/a
Vlan 10
L2 Protocol: NONE
Tagged: ethe 2/19
Vlan 20
L2 Protocol: NONE
Tagged: ethe 2/20