Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 729)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 705
53-1003031-02
Displaying additional BGP or MPLS VPN information
6
Displaying IP extcommunity list information
To display the IP Extcommunity information, enter the following command at any level of the CLI.
Brocade# show ip extcommunity-list
ip extcommunity access list 20:
permit RT 100:1
Syntax: show ip extcommunity-list
For information about the fields, refer to the following.
TABLE 134 Output of show IP extcommunity list
This field... Displays...
ip extcommunity access list The contents of all extended community lists on the Brocade
device.
Displaying the IP static route table for a VRF
To display the IP static route table for a VRF, enter the following command at any level of the CLI.
Brocade# show ip static route vrf green
IP Static Routing Table - entries:
IP Prefix Next Hop Interface Dis/Met/Tag Name
10.22.66.0/24 10.22.66.0 - 1/1/0 green
Syntax: show ip static route vrf vrf-name
The vrf-name parameter specifies the VRF that the user wants to display the static route table for.
Show run displays the entire name of the static IP route. The show ip static route command
displays an asterisk (*) after the first twelve characters when the assigned name is thirteen
characters or more. The show ipv6 static route command displays an asterisk after the first two
characters when the assigned name is three characters or more.
Displaying the static ARP table for a VRF
To display the static ARP table for a VRF, enter the following command at any level of the CLI.
Brocade# show ip static-arp vrf green
Static ARP table size: 2048, configurable from 2048 to 4096
Index IP Address MAC Address Port
1 10.95.6.111 2001:DB8.093b.d210 1/1
3 10.95.6.123 2001:DB8.093b.d211 1/1
Syntax: show ip static-arp vrf vrf-name
The vrf-name parameter specifies the VRF that the user wants to display the static ARP table for.