Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 571)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 547
53-1003031-02
Displaying MPLS VLL information
4
Layer 2 ACLs
When the port and VLAN combination of a Layer 2 ACL matches with any VLL endpoint, the ACL is
applied. For dual-tagged VLL endpoints, the Layer 2 ACL is applied based on the port and outer
VLAN combination, when it is configured.
Displaying MPLS VLL information
The user can display the following information about the MPLS VLL configuration on the device:
• Information about individual MPLS VLLs configured on the device
• Information about detailed MPLS VLLs configured on the device
• Information about LDP sessions between VLL peers
• Information about VLL Endpoint Statistics
• Information about packets sent between VLL endpoints and MPLS uplinks
Displaying information about MPLS VLLs
Use the following command to display information about MPLS VLLs.
Brocade# show mpls vll
Name VC-ID Vll-peer End-point State Tunnel-LSP
test 10 10.11.11.11 tag vlan 2 e 1/10 UP tn17
test2 100 -- tag vlan 100 inner-vlan 45 e2/1 DOWN
Syntax: show mpls vll
NOTE
Show commands have been enhanced to include the full MPLS name. Previously, the MPLS name
was truncated because it exceeded the character length. Now, the MPLS name is text wrapped to
display the full name.
For each MPLS VLL on the device, the following information is displayed.
TABLE 88 Output from the show mpls vll command
This field... Displays...
Name The configured name of the VLL.
VC-ID The user-configurable ID as defined in draft-ietf-pwe3-control-protocol-14.txt.
Vll-peer The remote PE router. This must be the same as the LSP destination for the
LSPs that the VLL is transported over.