Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 566)

542 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Transparent forwarding of L2 and L3 protocols on a VLL for CES and CER
4
Transparent forwarding of L2 and L3 protocols
on a VLL for CES and CER
Use the forward-all-control command to add per port Layer 2 and Layer 3 (L2/L3) protocols ACL
filters for the VLL end-point port. The command no forward-all-control removes the L2/L3 protocols
ACL filters for the VLL end point port.
NOTE
The forward-all-control command is only applicable to the Brocade NetIron CER and Brocade NetIron
CES.
To implement per port Layer 2 and Layer 3 (L2/L3) protocols ACL filters, enter the following
command.
Brocade(config)# int eth 1/1
Brocade (config-if-e1000-1/1)# forward-all-control
Syntax: [no] forward-all-control
The command no forward-all-control deletes VLL end point port L2/L3 protocols ACL filters. For
LAG, only the primary port needs to be configured.
NOTE
The forward-all-control command lets L2/L3 protocols on the port go with hardware forwarding
without going to the CPU. If the no forward-all-control command is executed, the L2/L3 functions
may be impacted.
The show interfaces ethernet slot/port command displays the configuration status of the
forward-all-control command.
The following output example shows the show interfaces ethernet slot/port command with the
forward-all-control command disabled.
Brocade# show interfaces ethernet 1/1
GigabitEthernet1/1 is up, line protocol is up
STP Root Guard is disabled, STP BPDU Guard is disabled
Hardware is GigabitEthernet, address is 001b.eda3.f841 (bia 001b.eda3.f841)
Configured speed auto, actual 1Gbit, configured duplex fdx, actual fdx
Member of 1 L2 VLAN(S) (tagged), port is in tagged mode, port state is
Forwarding
STP configured to ON, Priority is level0, flow control enabled
Priority force disabled, Drop precedence level 0, Drop precedence force disabled
dhcp-snooping-trust configured to OFF
mirror disabled, monitor disabled
LACP BPDU Forwarding:Disabled
LLDP BPDU Forwarding:Disabled
L2L3 protocols Forwarding:Disabled
Not member of any active trunks
…