Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 435)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 411
53-1003031-02
Displaying LDP information
2
Displaying information about LDP-enabled interfaces
To display information about the LDP-enabled interfaces on the LSR, enter the show mpls ldp
interface command.
Brocade# show mpls ldp interface
Label-space Nbr Hello Next
Interface ID Count Interval Hello
e4/1 0 1 5 0 sec
(targeted) 0 0 15 --
Syntax: show mpls ldp interface
TABLE 54 Output from the show mpls ldp interface command
This field... Displays...
Interface The slot and port number of the LDP-connected interface. “(targeted)” shows
information about unicast Targeted Hello messages sent to VLL peers.
Label-space ID The label space ID. For LSRs that use per-platform label spaces, the second
two octets are always zero.
Nbr Count The number of LDP peers/adjacencies that has been established on this
interface. This number can be greater than one (1) when this is a multi-access
network.
Hello Interval The number of seconds between LDP Hello messages.
Next Hello The number of seconds before the next LDP Hello message is sent (multicast)
to the LDP interface (non-targeted). For a targeted interface, the LDP Hello
message is unicast and, hence, for every neighbor, the next LDP Hello
message is sent at a different time. In order to find out when the next LDP
Hello message is sent out of any targeted adjacency, use the command show
mpls ldp neighbor.
Displaying information about specified LDP-enabled interface
To display information about a specific LDP enabled interface on the LSR, enter the following
command.
Brocade# show mpls ldp interface ethernet 4/1
e4/1(Trunk1), label-space ID: 0
Nbr count: 1
Hello interval: 7 sec, next hello: 2 sec
Hello timeout: 21 sec, hello timeout self: 0 sec
Syntax: show mpls ldp interface [ethernet slot/port | ve vid]