Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 807)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 783
53-1003031-02
Displaying VPLS auto-discovery information
8
Last Connection Reset Reason
(cont’d)
•
Reasons specific to the implementation:
•
Reset All Peer Sessions
•
User Reset Peer Session
•
Port State Down
•
Peer Removed
•
Peer Shutdown
•
Peer AS Number Change
•
Peer AS Confederation Change
•
TCP Connection KeepAlive Timeout
•
TCP Connection Closed by Remote
•
TCP Data Stream Error Detected
Notification Sent When the device sends a NOTIFICATION message to the neighbor, the
message contains an error code corresponding to one of the following errors.
Some errors have subcodes that clarify the reason for the error. Where
applicable, the subcode messages are listed underneath the error code
messages.
•
Message Header Error:
•
Connection Not Synchronized
•
Bad Message Length
•
Bad Message Type
•
Unspecified
•
Open Message Error:
•
Unsupported Version
•
Bad Peer As
•
Bad BGP Identifier
•
Unsupported Optional Parameter
•
Authentication Failure
•
Unacceptable Hold Time
•
Unspecified
•
Update Message Error:
•
Malformed Attribute List
•
Unrecognized Attribute
•
Missing Attribute
•
Attribute Flag Error
•
Attribute Length Error
•
Invalid Origin Attribute
•
Invalid NextHop Attribute
•
Optional Attribute Error
•
Invalid Network Field
•
Malformed AS Path
•
Unspecified
•
Hold Timer Expired
•
Finite State Machine Error
•
Cease
•
Unspecified
Notification Received When the device receives a NOTIFICATION message from the neighbor, the
message contains an error code corresponding to one of the following errors.
Some errors have subcodes that clarify the reason for the error. Where
applicable, the subcode messages are listed underneath the error code
messages.
See above.
TABLE 148 Output for the show ip bgp l2vpn vpls neighbors command (Continued)
This field... Displays...