Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 812)

788 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying VPLS auto-discovery information
8
Viewing a summary of BGP neighbor status
Use the show ip bgp l2vpn vpls summary command to view BGP4 summary information.
Brocade1# show ip bgp l2vpn vpls summary
BGP4 Summary
Router ID: 10.1.1.1 Local AS Number: 10
Confederation Identifier: not configured
Confederation Peers:
Maximum Number of IP ECMP Paths Supported for Load Sharing: 1
Number of Neighbors Configured: 1, UP: 1
Number of Routes Installed: 4, Uses 344 bytes
Number of Routes Advertising to All Neighbors: 2, Uses 88 bytes
Number of Attribute Entries Installed: 4, Uses 376 bytes
Neighbor Address AS# State Time Rt:Accepted Filtered Sent ToSend
10.1.1.2 10 ESTAB 0h 7m21s 2 0 2 0
Syntax: show ip bgp l2vpn vpls summary
Weight The value that this route associates with routes from a specific neighbor.
For example, when the Brocade device receives routes to the same
destination from two BGP4 neighbors, the device prefers the route from
the neighbor with the larger weight.
Status The route’s status. Refer to “Status” on page 787.
TABLE 151 Output for the show ip bgp l2vpn vpls summary command
This field... Displays
Router ID The Brocade device’s router ID.
Local AS Number The BGP4 AS number to which the Brocade device belongs.
Confederation Identifier The AS number of the confederation to which the Brocade device
belongs.
Confederation Peers The numbers of the local ASs contained in the confederation. This list
matches the confederation peer list the user configures on the Brocade
device.
Maximum Number of IP ECMP Paths
Supported for Load Sharing The maximum number of route paths across which the device can
balance traffic to the same destination.
Number of Neighbors Configured The number of BGP4 neighbors configured on this Brocade device, and
currently in established state.
Number of Routes Installed The number of BGP4 routes in the Brocade device’s BGP4 route table
and the route or path memory usage.
Number of Routes Advertising to All
Neighbors The total of the RtSent and RtToSend columns for all neighbors and the
amount of memory used by these routes.
Number of Attribute Entries Installed The number of BGP4 route-attribute entries in the device’s
route-attributes table and the amount of memory used by these entries.
Neighbor Address The IP addresses of this device’s BGP4 neighbors.
TABLE 150 Output for the show ip bgp l2vpn vpls routes command (Continued)
This field... Displays