Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 244)

220 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
MPLS LDP-IGP synchronization
1
The value parameter specifies the length of the EOL transmit label silence timer in milliseconds.
Possible values are from 100 to 60000 milliseconds. The default value is 1000.
Displaying LDP IGP synchronization information
Use the show isis config | show ip ospf config commands under config-isis-router | config-ospf
config policies to show the new configuration parameters for LDP-IGP sync:
• enable/disable for LDP-IGP sync
• Hold down time
Use the show isis configuration command to displaying IS-IS LDP IGP synchronization information.
Brocade(config-isis-router)# show isis config
router isis
net 10.0010.0100.1002.00
log adjacency
address-family ipv4 unicast
ldp-sync
metric-style wide
ldp-sync
ldp-sync hold-down 300
redistribute connected level-1
redistribute static
exit-address-family
address-family ipv6 unicast
ldp-sync
multi-topology transition
exit-address-family
end
Syntax: show isis configuration
Use the show ip ospf command to displaying IS-IS LDP IGP synchronization information.
Brocade# show ip ospf
OSPF Version Version 2
Router Id 10.1.1.2
ASBR Status No
ABR Status No (0)
Redistribute Ext Routes from
Initial SPF schedule delay 0 (msecs)
Minimum hold time for SPFs 0 (msecs)
Maximum hold time for SPFs 0 (msecs)
External LSA Counter 0
External LSA Checksum Sum 00000000
Originate New LSA Counter 9
Rx New LSA Counter 6
External LSA Limit 174762
Database Overflow Interval 0
Database Overflow State : NOT OVERFLOWED
RFC 1583 Compatibility : Enabled
Slow neighbor Flap-Action : Disabled, timer 300
Nonstop Routing: Disabled
Graceful Restart: Disabled, timer 120
Graceful Restart Helper: Enabled