Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 597)

Brocade# show mpls stat vll-local 4
VLL-Name End-point 1/2 VLL Port(s) VLL-Ingress-Pkts
--------- --------------- -------------- ------------------
test3 End-point1 e2/1 0
End-point2 e2/2 0
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 573
53-1003031-02
Enabling MPLS Local VLL traps
4
Syntax: show mpls statistics vll-local [vll-name | vll-id]
The vll-name variable is the configured name for a Local VLL instance.
The vll-id variable is the ID of a VLL instance.
For following information is displayed in the show mpls statistics vll command:
TABLE 98 Output from the show mpls vll-local command
This field... Displays...
VLL-Name The configured name of the Local VLL instance.
End-point 1/2 Either the End-point1 or End-point2 of the Local VLL instance
VLL Ports The port or ports that are assigned to the end point. When there are multiple ports, they are
members of a trunk.
VLL-Ingress-Pkts Packets arriving on the specified end point from outside the Local VLL.
Clearing the VLL traffic statistics
To clear the entries stored for all Local VLL statistics, enter a command such as the following.
Brocade# clear mpls statistics vll-local
Syntax: clear mpls statistics vll-local
Enabling MPLS Local VLL traps
The user can enable trap notification to be sent for Local VLLs by entering the following command.
Brocade(config)# snmp-server enable trap mpls vll-local
Syntax: [no] snmp-server enable trap mpls vll-local
Refer to the Unified IP MIB Reference for MPLS VLL trap notifications.