Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 611)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 587
53-1003031-02
BGP shortcuts
5
• Enable next-hop MPLS and observe the effect on the route to 10.8.8.1/32.
• Enable LSP-metric comparison and note that, because of the metric for LSP to22, it has no
effect on the routing table.
• Change the metric for an LSP (to2 in this example).
• Disable LSP-metric compare and check the consequences.
• Disable global next-hop MPLS
Specifying metrics
This step specifies metrics for three LSPs.
Brocade(config-bgp)# router mpls
Brocade(config-mpls)# lsp to2
Brocade(config-mpls-lsp-to2)# disable
Brocade(config-mpls-lsp-to2)# to 10.1.1.2
Brocade(config-mpls-lsp-to2)# from 10.1.1.1
Brocade(config-mpls-lsp-to2)# metric 10
Brocade(config-mpls-lsp-to2)# enable
Connecting signaled LSP to2
exit
....
Brocade(config-mpls)# lsp to22
Brocade(config-mpls-lsp-to22)# disable
Brocade(config-mpls-lsp-to22)# to 10.1.1.2
Brocade(config-mpls-lsp-to22)# from 10.1.1.1
Brocade(config-mpls-lsp-to22)# metric 20
Brocade(config-mpls-lsp-to22)# enable
Connecting signaled LSP to22
exit
....
Brocade(config-mpls)# lsp to2_sec
Brocade(config-mpls-lsp-to2_sec)# diable
Brocade(config-mpls-lsp-to2_sec)# to 10.10.1.2
Brocade(config-mpls-lsp-to2_sec)# from 10.10.1.1
Brocade(config-mpls-lsp-to2_sec)# metric 10
Brocade(config-mpls-lsp-to2_sec)# enable
Connecting signaled LSP to2_sec
exit
Brocade(config-mpls)# show mpls lsp
Admin Oper Tunnel Up/Dn Retry Active
Name To State State Intf Times No. Path
to2 10.1.1.2 UP UP tnl0 1 0 --
to2_sec 10.10.1.2 UP UP tnl2 1 0 --
to22 10.1.1.2 UP UP tnl1 1 0 --
Syntax: [no] metric num
Enable BGP ECMP
This example shows BGP ECMP being enabled and the check of the Routing Table Manager (RTM)
by the show ip route command. The destination for this example is 10.8.8.8/32, and native IP
forwarding is in effect.