Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 290)

Brocade# show mpls config interface ve 20
mpls-interface ve 20
ldp-enable
266 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying the Traffic Engineering database
1
Syntax: show mpls config interface [ethernet slot/port | pos slot/port | ve vid]
The ve parameter allows the user to limit the display to VE interface ID specified by the vid variable.
Displaying filtered MPLS configuration information
An individual MPLS interface, LSP, VLL, bypass, or VPLS can be specified in the show mpls config
command to display configuration of the specified object only. The following example displays the
MPLS configuration information for the LSP named “frr1”.
Brocade# show mpls config lsp frr1
lsp frr1
to 10.4.2.1
cos 6
ipmtu 1028
traffic-eng max-rate 180 mean-rate 125
metric 5
shortcuts ospf
frr
bandwidth 80
hop-limit 55
enable
Syntax: show mpls config lsp lsp-name | path path-name | interface interface-name | vll
vll-name | vll-local vll-local-name | vpls vpls-name | bypass bypass-name
The lsp option lets the user limit the display to configuration information for the LSP specified by
lsp-name.
The path option lets the user limit the display to configuration information for the path specified by
path-name.
The interface option allows the user to limit the display to configuration information for a specified
MPLS interface. The interface-name can be either a POS, Ethernet, or VE -enabled interface. A POS
or Ethernet interface is specified by interface type and slot/port. For example, ethernet 3/2
specifies an Ethernet interface on port 2 of the Interface module installed in slot 3. The VE
interface ID specified by the vid variable.
The vll option lets the user limit the display to configuration information for the VLL specified by
vll-name.
The vll-local option lets the user limit the display to configuration information for the Local VLL
specified by the vll-local-name variable.
The vpls option lets the user limit the display to configuration information for the VLL specified by
vpls-name.
The bypass-lsp option lets the user limit the display to information for the bypass LSP specified by
bypass-name.