Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 594)

570 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying Local VLL information
4
The ethernet port-id parameter specifies the port ID of the interface for which the user wants to
clear the counters.
The priority pri parameter specifies a priority queue for a particular Local VLL endpoint for which
the user wants to clear the counters.
Displaying Local VLL information
The user can display the following information about the Local VLL configuration on a Brocade
device:
• Information about individual Local VLLs configured on the router
• Information about VLL Endpoint Statistics
Displaying information about Local VLLs
To display brief information about Local VLLs.
Brocade# show mpls vll-local
Name VLL-ID End-point1 End-point2 State
foundrylong 1 tag vlan 100 e 5/12 undefined DOWN
vlllocalfou
ndrylongvll
localfoundr
ylongvllloc
alfoundry
test 2 tag vlan 200 inner-vlan 50 e 2/1 tag vlan 200 e 2/2 UP
Brocade
Syntax: show mpls vll-local
For each Local VLL on the device, the following information is displayed.
TABLE 96 Output from the show mpls vll-local brief command
This field... Displays...
Name The configured name of the Local VLL.
VLL-ID The VLL ID.
End-point How packets are forwarded out of the egress port of the Local VLL. This can be one of the
following:
•
“untagged portnum” – Forward the packet out the specified port as untagged.
•
“tag VLAN vlan_id / portnum” – Tag the packet with the specified VLAN ID and forward
the packet out the specified port.
•
“undefined” – An endpoint has not been configured for this Local VLL
•
“inner-vlan” – Describes the inner-VLAN tag for an end-point that is configured for
dual-tagging.
State The current state of the Local VLL. This can be either UP or DOWN. Data can be forwarded over
the Local VLL only when the state is UP.