Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 644)

620 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Configuring BGP VPNs on a PE
6
Configuring BGP VPNs on a PE
To configure a BGP VPN on a Provider Edge device (PE) the user must perform the configuration
steps listed below.
1. “Defining a VRF routing instance”
2. “Assigning a Route Distinguisher to a VRF”
3. “Defining IPv4 or IPv6 address families of a VRF”
4. “Defining automatic route filtering”
5. “Assigning a VRF routing instance to an interface”
6. “Assigning a VRF routing instance to a LAG interface”
7. “Setting up cooperative route filtering”
8. “Importing and exporting route maps”
9. “Defining an extended community for use with a route map”
10. “Creating a VPNv4 route reflector”
11. “Configuring BGP VRF load sharing”
12. “Configuring autonomous system number override”