Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 347)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 323
53-1003031-02
show mpls ldp fec prefix
2
show mpls ldp fec prefix
An additional column is added in the output of this command to indicate that the FEC is filtered
because of Inbound (In) or Outbound (Out) FEC filter action or if it is not filtered ( - ). The filtered
prefix FEC counter now includes counters for both inbound and outbound filtered FEC.
Syntax show mpls ldp fec [prefix [A.B.C.D/filtered/prefix-filter prefix_list_name]]
Parameters prefix
The prefix option displays the total number of Layer FECs specified by the A.B.C.D, filtered, or
prefix-filter variable.
Command
modes
This command operates in all modes.
Usage guidelines The filtered prefix FEC counter now includes counters for both inbound and outbound filtered FEC.
Command
output
Command output Description
Total number of
prefix FECs The total number of Layer 3 FECs.
Total number of
prefix FECs installed The total number of Layer 3 FECs installed.
Total number of
prefix FECs filtered
(in/out) The total number of Layer 3 FECs filtered.
Destination The IP Prefix associated with the host address or the prefix FEC type.
State State of the FEC which indicates the FEC advertised to any LDP session (state equal to
‘current’. When it has no session, it is either called ‘cur_no_sess’ (currently no session)
for local FECs or is marked “retained” for non-local FECs.
Out-intf For an ingress FEC, this mentions the output interface to reach to the Next-hop. The
‘Out-Intf’ field displays the egress interface associated with the FEC entry. When
applicable, the ‘Out-Intf’ field displays a VE interface specified by the vid variable.
Next-hop For an ingress FEC, this mentions the next-hop IP address.
Ingress Whether the FEC is an ingress FEC.
Egress Whether the FEC is an egress FEC.
Filtered The FEC is filtered Inbound (In) or Outbound (Out) or is not filtered ( - ).
The show mpls ldp fec prefix command displays the following information.
Example
Brocade# show mpls ldp fec prefix
Total number of prefix FECs: 6
Total number of prefix FECs installed: 1
Total number of prefix FECs filtered (in/out): 2/2
Destination State Out-intf Next-hop Ingress Egress Filtered
10.14.14.14/32 current -- -- No Yes -
192.168.1.1/32 current e2/1 10.23.23.12 Yes No In