Displaying vll extended counters – Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual
Page 568
544
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying VLL extended counters
4
When the extended counters are disabled globally, the user can enable the extended counters for a
particular VLL instance by entering the following command.
Brocade(config-mpls-vll-test10)# extended-counters on
Syntax: [no] extended-counters [on | off]
The on option enables extended counters for a particular VLL instance. The off option disables
extended counters for a particular VLL instance.
Displaying VLL extended counters
When extended counters are enabled for a particular VLL instance either by default or explicit
configuration, the user can display the number of bytes and packets received and sent on a
particular endpoint or all the endpoints of that particular VLL instance. The counters are displayed
whether or not the per-VLAN, port, and priority-based accounting mode is enabled at the global
configuration level.
When the per-VLAN, port, and priority-based accounting mode is enabled at the global
configuration level, the following output is displayed for the show mpls statistics vll
extended-counters command.
Brocade# show mpls statistics vll vll78 extended-counters
VLL vll78, VLL-ID 78: Extended Counters (only applicable for G2 modules)
VLAN
Port
RxPkts
TxPkts
RxBytes
TxBytes
74
5/2
0
0
0
0
p0
0 0 0 0
p1
0 0 0 0
p2
0 0 0 0
p3
0 0
0 0
p4
0 0 0
0
p5
0 0 0 0
p6
0 0 0 0
p7
0 0
0 0
When the per-VLAN, port, and priority-based accounting mode is disabled, the following output is
displayed for the show mpls statistics vll extended-counters command.
Brocade# show mpls statistics vll vll78 extended-counters
VLL vll78, VLL-ID 78: Extended Counters (only applicable for G2 modules)
VLAN
Port
RxPkts
TxPkts
RxBytes
TxBytes
74
5/2
0
0
0
0
Syntax: show mpls statistics vll [vll-name | vll-id [extended-counters [[vlan vlan-id] [ethernet
port-id]]]]
The vll-name parameter specifies the configured name for a VLL instance.
The vll-id parameter specifies the ID of a VLL instance.
The extended-counters keyword enables the extended counters for a particular VLL instance.
The vlan vlan-id parameter specifies the ID of the configured VLAN.