Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 598)

574 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Disabling Syslog messages for MPLS VLL-local and VLL
4
Disabling Syslog messages for MPLS VLL-local and VLL
Transitions of VLL local instances from an up state to a down state and vice versa are logged by
default. The user can disable the logging of these events by entering the following command.
Brocade(config)# no logging enable mpls
Syntax: [no] logging enable mpls
Similarly, the generation of Syslog message for MPLS VLL events are enabled by default. The user
can disable the logging of these event by entering the following command.
Brocade(config)# no logging enable mpls vll
Syntax: [no] logging enable mpls vll
VLL raw-pass-through overview
This feature is in addition to the NetIron R05.5.00 software release for the NetIron product line.
The raw-mode and tagged-mode supports are for both CES and XMR platforms. In the
raw-pass-through mode, VLL instance behaves similar to either tagged-mode or raw-mode based
on the VLL endpoint configuration and similar to tagged-mode fora tagged endpoint and raw-mode
for an untagged endpoint.
Packet formats and VC mode definitions
The expected raw-mode packet and tagged-mode packet formats are shown below.