Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 314)

290 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Transit LSP statistics
1
Protected LSP shown in RSVP session
Show the MPLS RSVP session for protected LSP xmr3-199. The line “Backup LSP UP. Nexthop
(node) protection available” shows that protection is available for xmr-199. If this LSP were actually
riding the bypass LSP, this status would change from “protection available” to “in use.”.
Brocade-XMR5(config-mpls-bypasslsp-123)# show mpls rsvp sess name xmr3-199
Codes: DI:Ingress Detour DT:Transit Detour DM:Merged Detour
DE:Egress Detour BI:Ingress Backup BM: Merged Backup BE:Egress Backup
RP:Repaired Session BYI: Bypass Ingress
To From State Style Lbl_in Lbl_out LSP name
10.33.33.33 10.55.55.55 Up SE - 2399 xmr3-199
Tunnel ID: 121, LSP ID: 1
Time left in seconds (PATH refresh: 11, ttd: 137
RESV refresh: 8, ttd: 138)
Tspec: peak 0 kbps rate 0 kbps size 0 bytes m 20 M 65535
Fast Reroute: Facility backup desired
Setup priority: 4, hold priority: 3
Bandwidth: 0 kbps, hop limit: 255
Backup LSP: UP. Nexthop (node) protection available.
Up/Down times: 1, num retries: 0
Explicit path hop count: 4
10.0.0.1 (S) -> 10.0.0.38 (S) -> 10.0.0.2 (S) -> 10.0.0.9 (S)
Received RRO count: 4
Protection codes: P: Local N: Node B: Bandwidth I: InUse
10.0.0.1 -> 10.0.0.38 -> 10.0.0.2 ->
10.0.0.9
PATH sentto: 10.0.0.1 (e3/1 ) (MD5 OFF)
RESV rcvfrom: 10.0.0.1 (e3/1 ) (MD5 OFF)
To From State Style Lbl_in Lbl_out LSPname
10.33.33.33 10.0.0.2(BI) Up SE - 3 xmr3-199
Tunnel ID: 121, LSP ID: 1
Time left in seconds (PATH refresh: 0, ttd: 4196607
RESV refresh: 8, ttd: 4196765)
Tspec: peak 0 kbps rate 0 kbps size 0 bytes m 20 M 65535
Explicit path hop count: 1
10.0.0.21 (S)
Backup Sent
PATH sentto: 10.0.0.21 (e2/13 ) (MD5 OFF)
RESV rcvfrom: 10.0.0.21 (e2/13 ) (MD5 OFF)
Riding bypass lsp: xmr3-1
Syntax: show mpls rsvp session name name
A protected LSP while the bypass LSP is active
This section shows two views of a protected LSP while the bypass LSP is active.
To show a protected LSP while its bypass LSP is active, display the RSVP session for the LSP named
xmr3-120. This bypass LSP is on LAG p4/3, and two lines in the output show that xmr3-120 is
riding xmr1-by.