Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 299)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 275
53-1003031-02
Transit LSP statistics
1
The following is the MPLS Fast Reroute configuration for Ingress Router 4.
Router4(config)# interface loopback 1
Router4(config-lbif-1)# ip address 10.4.4.4/24
Router4(config)# interface ethernet 2/1
Router4(config-if-e1000-2/1)# ip address 10.10.10.2/24
Router4(config)# interface ethernet 2/9
Router4(config-if-e1000-2/9)# ip address 10.13.13.1/24
Router4(config)# router mpls
Router4(config-mpls)# mpls-interface ethernet 2/1 ethernet 2/9
Router4(config-mpls)# path a
Router4(config-mpls-path-a)# strict 10.2.2.2
Router4(config-mpls-path-a)# strict 10.6.6.6
Router4(config-mpls)# lsp 1
Router4(config-mpls-lsp-1)# to 10.5.5.5
Router4(config-mpls-lsp-1)# primary-path a
Router4(config-mpls-lsp-1)# frr
Displaying RSVP session information for example network
The show mpls rsvp session command, provides information regarding the primary and detour
routes in an MPLS RSVP Fast Reroute enabled network. Display examples are provided for the
following routers in the configuration shown in
Figure 44 :
• Transit Router 6
• Transit Router 2
• Ingress Router 4
• Transit Router 3
• Transit Router 1
• Egress Router 5
The following examples include displays for the show mpls rsvp session and show mpls rsvp
session detail commands. For a general description of the command and its output refer to
“Displaying RSVP session information” .