Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 284)

260 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying the Traffic Engineering database
1
Brocade# show mpls lsp frr_tunnel
LSP frr_tunnel, to 10.4.4.4
From: 10.1.1.1, admin: UP, status: UP, tunnel interface: tnl4
Times primary LSP goes up since enabled: 1
Metric: 0, number of installed aliases: 0
Maximum retries: 0, no. of retries: 0
Pri. path: p1, active: yes
Path specific attributes:
Tunnel interface: tnl4, outbound interface: e1/1
Setup priority: 7, hold priority: 0
Max rate: 0 kbps, mean rate: 0 kbps, max burst: 0 bytes
Constraint-based routing enabled: yes
Tie breaking: random, hop limit: 0
Explicit path hop counts: 3
11.1.1.2 (S) -> 13.1.1.2 (S) -> 15.1.1.2 (S)
Recorded routes:
Protection codes: P: Local N: Node B: Bandwidth I: InUse
11.1.1.2 (PNB) -> 13.1.1.2 (PNB) -> 15.1.1.2
Fast Reroute: one-to-one backup desired
Bandwidth: 1024 kbps
Detour LSP: UP, out-label: 1028, outbound interface: e1/3
Output that is shown in bold is unique to the show mpls lsp command when the LSP is configured
for Fast Reroute by way of detour backup. The output is described in
Table 32 . Fields that are
common to the output from the show mpls lsp command when an LSP is not configured for Fast
Reroute are described in
“Displaying signaled LSP status information” .
TABLE 32 Output from the show mpls lsp command
This field... Displays...
Fast Reroute The method of Fast Reroute configured for this LSP. Currently only one-to-one backup is
available.
Bandwidth The bandwidth in Kilobits/sec for the bypass route. A value of 0 means that the detour route
uses a best effort value for bandwidth.
Detour LSP Indicates when the detour route is Up or Down.
out-label The outbound label used when sending traffic over a detour LSP.
outbound
interface The physical interface on the router that is used for the detour route.
Displaying adaptive bypass LSP information
Enter the show mpls bypass-lsp name command to display information about a bypass LSP.