Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 679)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 655
53-1003031-02
Displaying BGP or MPLS VPNv4 information
6
Displaying Flap statistics for a specified VPNv4 neighbor by IP address
To display flap-statistics for routes learned from the specified VRF neighbor, enter the following
command at any level of the CLI.
R3-2547(config)# show ip bgp vpnv4 neighbors 10.2.2.2 flap-statistics
Total number of flapping routes: 0
Syntax: show ip bgp vpnv4 vrf-name neighbor ip-addr flap-statistics
The vrf-name parameter specifies the VPNv4 neighbor the user wants to display flap-statistics for.
The address / mask parameter specifies a particular route. When the user also uses the optional
longer-prefixes parameter, then all statistics for routes that match the specified route or have a
longer prefix than the specified route are displayed. For example, when the user specifies
10.157.0.0 longer, then all routes with the prefix 10.157 or that have a longer prefix (such as
10.157.22) are displayed.
This display shows the following information.
TABLE 116 Route flap dampening statistics
This field... Displays...
Total number of flapping routes The total number of routes in the device’s BGP4 route table that have
changed state and thus have been marked as flapping routes.
Atomic Whether the network information in this set of attributes has been
aggregated and this aggregation has resulted in information loss:
•
TRUE – Indicates information loss has occurred
•
FALSE – Indicates no information loss has occurred
NOTE: Information loss under these circumstances is a normal part of
BGP4 and does not indicate an error.
Local Pref The degree of preference for routes that use this set of attributes relative
to other routes in the local AS.
Communities The communities that routes with this set of attributes are in.
Extended Community The extended community attributes of the device.
AS Path The ASs through which routes with this set of attributes have passed. The
local AS is shown in parentheses.
Address This field is for internal Brocade debugging purposes only.
Hash This field is for internal Brocade debugging purposes only.
Reference Counts This field is for internal Brocade debugging purposes only.
TABLE 115 BGP4 route-attribute entries information (Continued)
This field... Displays...