Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 720)

696 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying additional BGP or MPLS VPN information
6
Displaying ARP VRF information
To display the ARP information for a specified VRF, enter the following command.
Brocade# show arp vrf green
Total number of ARP entries: 9
Entries in VRF green:
IP Address MAC Address Type Age Port
1 192.168.201.2 2001:DB8.52cf.e840 Dynamic 0 6/3
Syntax: show arp vrf vrf-name [number] [ip-address] [ethernet slot/port] [mac-address mac-addr]
The vrf-name parameter specifies the VRF that the user wants to display arp entries for.
To clear the ARP table.
Brocade# clear arp vrf green
Syntax: clear arp vrf vrf-name
Displaying OSPF information for a VRF
To display the OSPF Information for a specified VRF, enter the following command at any CLI level.
Brocade# show ip ospf vrf green
OSPF Version Number Version 2
Router Id 192.168.201.1
Domain Id 10.2.2.2
Domain Tag 10.2.2.2
ASBR Status Yes
ABR Status Yes (1)
Redistribute Ext Routes from BGP
External LSA Counter 96
Originate New LSA Counter 1738
Rx New LSA Counter 173
External LSA Limit 14447047
Database Overflow Interval 0
Database Overflow State : NOT OVERFLOWED
RFC 1583 Compatibility : Enabled
Syntax: show ip ospf vrf vrf-name [area [area-id | area-ipaddress]] [border-routers router-id]
[config] [database [database-summary | external-link-state [advertise number] |
extensive | link-state-id id-number |router-id advertising-router-id | sequence-number
HEX] [link-state [advertise number] | sabre
The vrf-name parameter specifies the VRF that the user wants to display OSPF information for.