Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual
Page 246
222
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
MPLS LDP-IGP synchronization
1
Displaying the show mpls ldp configuration
Use the sh mpls ldp command to view the extended parameters.
Label Distribution Protocol version 1
LSR ID: 10.1.7.1, using Loopback 1
(deleting it stops LDP)
Hello interval: Link 5 sec, Targeted 15 sec
Hold time value sent in Hellos: Link 15 sec, Targeted 45 sec
Keepalive interval: 6 sec, Hold time multiple: 6 intervals
Load sharing: 8
Tunnel metric: 0
FEC used for auto discovered peers: current 129, configured 129
Graceful restart: enabled
Reconnect time: 120 seconds, Max peer reconnect time: 120 seconds
Recovery time: 120 seconds, Max peer recovery time: 120 seconds
Forwarding state holding timer: not running
End of lib: Enabled, Notification time: 120000 ms, Tx label silence time: 5000ms
End of lib: Disabled, Recieve Label Silence Time: 5000ms
Syntax: sh mpls ldp
Displaying the show mpls ldp sessions
Use the sh mpls ldp sess command to view LDP-IGP sync information. When the timers are running
the remaining time appears (no refresh) as well as the static value of the timer.
Brocade# show mpls ldp sess 10.7.7.2 0
Peer LDP ID: 10.7.7.2:0, Local LDP ID: 10.1.7.1:0, State: Operational
Adj: Link, Role: Passive, Next keepalive: 1 sec, Hold time left: 31 sec
Keepalive interval: 6 sec, Max hold time: 36 sec
Up time: 16 min 46 sec
Neighboring interfaces: e2/2
TCP connection: 10.1.7.1:646--10.7.7.2:9004, State: ESTABLISHED
Next-hop addresses received from the peer:
10.1.1.14 10.1.2.14 10.3.4.5 10.7.7.2
Graceful restart: enabled
Peer reconnect time(msec): 120000, peer recovery time(msec): 0
State: not started
IGP Sync:
Unrecognized Notification Capability: Local: On, Remote: On
Local State: In-sync, RemoteState: In-sync
EOL notification time: 60000 ms, Timer not running
EOL transmit label silence time: 1000 ms, Timer not running
Syntax: sh mpls ldp sess value
Displaying the show mpls ldp interface
Use the show mpls ldp int command to view whether or not LDP-IGP sync is enabled on the
interface.
Brocade# sh mpls ldp int e2/16
e2/16, label-space ID: 0
Nbr count: 1
Hello interval: 5 sec, next hello: 2 sec
Hello timeout: 15 sec
Current IGP Sync state: In Sync
Syntax: show mpls ldp int value