Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 461)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 437
53-1003031-02
label-withdrawal-delay
2
label-withdrawal-delay
Delays sending a label withdrawal message for a FEC to a neighbor. in order to allow the IGP and
LDP to converge. The no form of this command restores the default behavior.
Syntax label-withdrawal-delay secs
no label-withdrawal-delay secs
Command
Default
The label withdrawal delay timer is enabled. The delay period is 60 seconds.
Parameters secs
Specifies the delay period for the label withdrawal delay timer in seconds. The range is 0 - 300.
The default is 60.
Command
Modes
Router mpls-ldp subconfiguration mode
Usage
Guidelines
Setting the secs variable to 0 disables the feature for subsequent events.
Setting the secs variable to a value in the range 1 - 300, updates the configured value.
When you use the [no] form of the command to restore the default behaviour, the value you
specify for the secs variable must match the configured value at the time that the no form of the
command is executed.
Examples The following example sets the label withdrawal delay timer to 30 seconds.
Brocade(config-mpls-ldp)# label-withdrawal-delay 30
The following example restores the command default behaviour when the delay period is already
configured as 30 seconds,
Brocade(config-mpls-ldp)# no label-withdrawal-delay 30
The following example disables the label withdrawal delay timer.
Brocade(config-mpls-ldp)# label-withdrawal-delay 0
History
Release Command history
Multi-Service IronWare R05.5.00 This command was introduced.
Related
Commands