Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 696)

672 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying BGP or MPLS VRF information
6
The neighbor ip-addr parameter displays route flap dampening statistics only for routes learned
from the specified neighbor. The user also can display route flap statistics for routes learned from a
neighbor by entering the following command: show ip bgp neighbor ip-addr flap-statistics.
The regular-expression regular-expression parameter is a regular expression. The regular
expressions are the same ones supported for BGP4 AS-path filters.
This display shows the following information.
TABLE 124 Route flap dampening statistics
This field... Displays...
Total number of flapping routes The total number of routes in the device’s BGP4 route table that have
changed state and thus have been marked as flapping routes.
The user can also display all the dampened routes by entering the following command:
show ip bgp dampened-paths.
Displaying BGP neighbor information for a specified VRF
To view BGP4 configuration information and statistics for a specified VRF’s neighbors, enter the
following command.
Brocade# show ip bgp vrf black neighbor
Total number of BGP Neighbors: 3
1 IP Address: 10.10.2.3, AS: 206 (EBGP), RouterID: 10.10.2.3, VRF: black
State: ESTABLISHED, Time: 14h31m51s, KeepAliveTime: 60, HoldTime: 180
KeepAliveTimer Expire in 4 seconds, HoldTimer Expire in 135 seconds
Messages: Open Update KeepAlive Notification Refresh-Req
Sent : 1 4 871 0 0
Received: 1 1 873 0 0
Last Update Time: NLRI Withdraw NLRI Withdraw
Tx: --- --- Rx: --- ---
Last Connection Reset Reason:Unknown
Notification Sent: Unspecified
Notification Received: Unspecified
Neighbor NLRI Negotiation:
Peer Negotiated IPV4 unicast capability
Peer configured for IPV4 unicast Routes
TCP Connection state: ESTABLISHED
TTL check: 0, value: 0, rcvd: 64
Byte Sent: 17543, Received: 16814
Local host: 10.10.2.1, Local Port: 8135
Remote host: 10.10.2.3, Remote Port: 179
ISentSeq: 3301937 SendNext: 3319481 TotUnAck: 0
TotSent: 17544 ReTrans: 0 UnAckSeq: 3319481
IRcvSeq: 466270178 RcvNext: 466286993 SendWnd: 6432
TotalRcv: 16815 DupliRcv: 285 RcvWnd: 65000
SendQue: 0 RcvQue: 0 CngstWnd: 1456
This example shows how to display information for a specific VRFs neighbor. None of the other
display options are used; thus, all of the information is displayed for the neighbor. The number in
the far left column indicates the neighbor for which information is displayed. When the user lists
information for multiple neighbors, this number makes the display easier to read.