Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual
Page 383
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
359
53-1003031-02
MPLS LDP-IGP synchronization
2
Level-2 Metric: 10, Level-2 Priority: 64
Level-2 Hello Interval: 10 Level-2 Hello Multiplier: 3
Level-2 Designated IS: R2-03 Level-2 DIS Changes: 2
Next IS-IS LAN Level-1 Hello in 7 seconds
Next IS-IS LAN Level-2 Hello in 3 seconds
Number of active Level-1 adjacencies: 0
Number of active Level-2 adjacencies: 0
Circuit State Changes: 1 Circuit Adjacencies State Changes: 0
Rejected Adjacencies: 0
Circuit Authentication L1 failures: 0
Circuit Authentication L2 failures: 0
Bad LSPs: 0
Control Messages Sent: 40 Control Messages Received: 0
Hello Padding: Enabled
IP Enabled: TRUE
IP Addresses:
10.30.30.2/28
IPv6 Enabled: FALSE
MPLS TE Enabled: FALSE
LDP-SYNC: Disabled, State:
Syntax: show [isis|ip ospf] interface
Displaying the show mpls ldp configuration
Use the show mpls ldp command to view the extended parameters.
Label Distribution Protocol version 1
LSR ID: 10.1.7.1, using Loopback 1
(deleting it stops LDP)
Hello interval: Link 5 sec, Targeted 15 sec
Hold time value sent in Hellos: Link 15 sec, Targeted 45 sec
Keepalive interval: 6 sec, Hold time multiple: 6 intervals
Load sharing: 8
Tunnel metric: 0
FEC used for auto discovered peers: current 129, configured 129
Graceful restart: enabled
Reconnect time: 120 seconds, Max peer reconnect time: 120 seconds
Recovery time: 120 seconds, Max peer recovery time: 120 seconds
Forwarding state holding timer: not running
End of lib: Enabled, Notification time: 120000 ms, Tx label silence time: 5000ms
End of lib: Disabled, Recieve Label Silence Time: 5000ms
Syntax: show mpls ldp
Use the show mpls ldp session command to view LDP-IGP sync information. When the timers are
running the remaining time appears (no refresh) as well as the static value of the timer.
Brocade# show mpls ldp session 10.7.7.2 0
Peer LDP ID: 10.7.7.2:0, Local LDP ID: 10.1.7.1:0, State: Operational
Adj: Link, Role: Passive, Next keepalive: 1 sec, Hold time left: 31 sec
Keepalive interval: 6 sec, Max hold time: 36 sec
Up time: 16 min 46 sec
Neighboring interfaces: e2/2
TCP connection: 10.1.7.1:646--10.7.7.2:9004, State: ESTABLISHED
Next-hop addresses received from the peer:
10.1.1.14 10.1.2.14 10.3.4.5 10.7.7.2