Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 426)

TABLE 48 Output from the show mpls ldp path command
This field... Displays...
Upstr-session(label) The LDP identifier of the upstream peer, as well as the incoming label.
Note that upstream session information does not apply to LSPs for which this
is the ingress LER.
Because the device uses a per-platform label space, the incoming interface for
LDP-created LSP is not relevant.
Downstr-session(label, intf) The LDP identifier of the downstream peer, as well as the outgoing label and
interface. When applicable, the ingress interface (intf) field displays a VE
interface specified by the vid variable.
Note that downstream session information does not apply to LSPs for which
this is the egress LER. When LDP selects its outgoing interface as an RSVP
tunnel, the ingress interface (intf) field displays the RSVP tunnel name.
Destination route The destination route bound to this LSP.
402 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying LDP information
2
Displaying LDP tunnel LSP information
The show mpls ldp tunnel command has been enhanced to have a filter for tunnel destination
prefix. Two options, 'brief' and 'detail' have been added to this command. Tunnel destination prefix
can be either IPv4 host address or IPv4 prefix with subnet mask. Output of the command with the
path destination prefix filter displays a single tunnel entry for a specified tunnel destination IP
prefix. The format of the command output for a tunnel destination filtered command is in detailed
format. The 'brief' option displays the output similar to the example below. The 'detail' option
displays all the tunnel entries in detailed format. Additionally existing show mpls ldp tunnel
command output has been enhanced to show the total number of LDP tunnels.
To display information about LDP-created LSPs for which this device is the ingress LER, enter the
following command.