Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 836)

812 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying 6PE information
9
Displaying the error information for the 6PE neighbors
Issue the show ip bgp 6pe neighbors last-packet-with-error command to display error information
for the 6PE neighbors. For example, to display error information for the 6PE neighbors in the
configuration in
Figure 95 , enter the following command.
6PE2# show ip bgp 6pe neighbors last-packet-with-error
Total number of BGP Neighbors: 1
No received packet with error logged for any neighbor
Syntax: show ip bgp 6pe neighbors last-packet-with-error
Table 157 describes the output parameters of the show ip bgp 6pe neighbors
last-packet-with-error command.
TABLE 157 Output parameters of the show ip bgp 6pe neighbors last-packet-with-error
command
Field Description
Total number of BGP Neighbors Shows the total number of neighbors configured for the 6PE router.
Last error Shows the decoded error packet contents or the notification that no
packets with an error were received.
Displaying the routes summary of the 6PE neighbors
Issue the show ip bgp 6pe neighbors routes-summary command to display the routes summary for
the 6PE neighbors. For example, to display the routes summary for the 6PE neighbors in the
configuration in
Figure 95 , enter the following command.
6PE2# show ip bgp 6pe neighbors routes-summary
Total number of BGP Neighbors: 1
1 IP Address: 10.30.30.1
Routes Accepted/Installed:2, Filtered/Kept:0, Filtered:0
Routes Selected as BEST Routes:2
BEST Routes not Installed in IP Forwarding Table:0
Unreachable Routes (no IGP Route for NEXTHOP):0
History Routes:0
NLRIs Received in Update Message:2, Withdraws:0 (0), Replacements:0
NLRIs Discarded due to
Maximum Prefix Limit:0, AS Loop:0
Invalid Nexthop:0, Invalid Nexthop Address:0.0.0.0
TotalRcv Shows the count of the sequence numbers received from the neighbor.
DupliRcv Shows the count of the duplicate sequence numbers received from the neighbor.
RcvWnd Shows the size of the receive window.
SendQue Shows the count of the sequence numbers in the send queue.
RcvQue Shows the count of the sequence numbers in the receive queue.
CngstWnd Shows the number of times the window has changed.
TABLE 156 Output parameters of the show ip bgp 6pe neighbors command (Continued)
Field Description