Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 581)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 557
53-1003031-02
Sample MPLS VLL configuration
4
Brocade(config)# interface e 2/1
Brocade(config-if-e1000-2/1)# port-name Connection_to_R2
Brocade(config-if-e1000-2/1)# enable
Brocade(config-if-e1000-2/1)# ip address 192.168.37.1/30
Brocade(config-if-e1000-2/1)# ip ospf area 0
Brocade(config-if-e1000-2/1)# exit
Router R2
The following commands configure Router R2 in Figure 60 .
Brocade(config)# ip router-id 192.168.2.101
Brocade(config)# router ospf
Brocade(config-ospf-router)# area 0
Brocade(config-ospf-router)# exit
Brocade(config)# router mpls
Brocade(config-mpls)# mpls-interface e 4/1 to e 4/2
Brocade(config-mpls)# policy
Brocade(config-mpls-policy)# traffic-engineering ospf
Brocade(config-mpls-policy)# exit
Brocade(config)# interface e 4/1
Brocade(config-if-e1000-4/1)# enable
Brocade(config-if-e1000-4/1)# ip address 192.168.37.2/30
Brocade(config-if-e1000-4/1)# ip ospf area 0
Brocade(config-if-e1000-4/1)# exit
Brocade(config)# interface e 4/2
Brocade(config-if-e1000-4/2)# enable
Brocade(config-if-e1000-4/2)# ip address 192.168.41.2/30
Brocade(config-if-e1000-4/2)# ip ospf area 0
Brocade(config-if-e1000-4/2)# exit
Brocade(config)# interface loopback 1
Brocade(config-lbif-1)# port-name Generic All-Purpose Loopback
Brocade(config-lbif-1)# ip address 192.168.2.101/32
Brocade(config-lbif-1)# ip ospf area 0
Brocade(config-lbif-1)# exit
Router R3
The following commands configure Router R3 in Figure 60 .
Brocade(config)# ip router-id 192.168.2.102
Brocade(config)# router ospf
Brocade(config-ospf-router)# area 0
Brocade(config-ospf-router)# exit
Brocade(config)# router mpls
Brocade(config-mpls)# mpls-interface e 2/1
Brocade(config-mpls)# policy
Brocade(config-mpls-policy)# traffic-engineering ospf
Brocade(config-mpls-policy)# exit
Brocade(config-mpls)# lsp Tunnel_To_R1
Brocade(config-mpls-lsp)# to 192.168.2.100
Brocade(config-mpls-lsp)# enable
Brocade(config-mpls-lsp)# exit