Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 427)

Brocade# show mpls ldp tunnel
Total number of LDP tunnels : 3
Oper Tunnel Outbound
To State Intf Intf
10.22.22.22/32 UP tnl2 e2/3 e3/3 (Trunk11)
10.33.33.33/32 UP tnl3 e2/3 (Trunk11)
10.44.44.44/32 UP tnl4 ve55
Brocade# show mpls ldp tunnel brief
Total number of LDP tunnels : 3
Oper Tunnel Outbound
To State Intf Intf
10.22.22.22/32 UP tnl2 e2/3 (Trunk11)
10.33.33.33/32 UP tnl3 e2/3 (Trunk11)
10.44.44.44/32 UP tnl4 ve55
Brocade# show mpls ldp tunnel 10.22.22.22
LDP tunnel tnl2, to 10.22.22.22/32
Tunnel index: 2, metric: 0, status: UP
Outgoing interface: e2/3 (Trunk11), Next-hop index: 0
Brocade# show mpls ldp tunnel 10.44.44.44/32
LDP tunnel tnl4, to 10.44.44.44/32
Tunnel index: 4, metric: 0, status: UP
Outgoing interface: ve55, Next-hop index: 1
Brocade# show mpls ldp tunnel detail
Total number of LDP tunnels : 3
LDP tunnel tnl2, to 10.22.22.22/32
Tunnel index: 2, metric: 0, status: UP
Outgoing interface: e2/3 (Trunk11), Next-hop index: 0
LDP tunnel tnl3, to 10.33.33.33/32
Tunnel index: 3, metric: 0, status: UP
Outgoing interface: e2/3 (Trunk11), Next-hop index: 0
LDP tunnel tnl4, to 10.44.44.44/32
Tunnel index: 4, metric: 0, status: UP
Outgoing interface: ve55, Next-hop index: 1
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 403
53-1003031-02
Displaying LDP information
2
Syntax: show mpls ldp tunnel [destination-ip-address | ip-mask] [brief | detail]
The following table describes the output of the show mpls ldp tunnel command.
TABLE 49 Output from the show mpls ldp tunnel command
This field... Displays...
Tunnel Name Name of the tunnel.
To The egress LER for the LSP.
Status The operational state of the LSP. This field indicates whether the LSP has been established
through LDP signalling and is capable of having packets forwarded through it.
Tunnel Index Tunnel index of the current tunnel.
Outgoing
Interface The outbound interface for the LSP. The outbound interface displays the egress interface of the
tunnel. Multiple outbound ports are separated by spaces. When applicable, the egress
interface of the tunnel displays a VE interface specified by the vid variable.