Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual
Page 267
Brocade# show mpls path
Path Name Address Strict/loose Usage Count
to110_120 10.110.110.2 Strict 1
10.120.120.3 Strict
to2_pri 10.10.10.2 Strict 0
to2_sec 10.110.110.2 Strict 0
to3 10.110.110.2 Loose 1
10.120.120.3 Loose
to3_pri 10.10.10.2 Strict 1
10.20.20.3 Strict
to3_sec 10.110.110.2 Strict 0
10.120.120.3 Strict
to4 10.110.110.2 Loose 1
10.120.120.3 Loose
10.130.130.4 Loose
to_23 10.110.110.2 Strict 1
10.20.20.3 Strict
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
243
53-1003031-02
Displaying the Traffic Engineering database
1
Syntax: show mpls path [path-name]
The user can display information for all paths configured on the device, or for a specified
path-name.
describes the output shown in the show mpls path command.
TABLE 24
Output of the show mpls path command
This column...
Displays...
Path Name
The configured name of the path.
Address
The IP address of each node in the path. A node corresponds to an MPLS-enabled
router in the network.
Strict or loose
Whether the node is strict or loose. A strict node means that the router must be
directly connected to the preceding node. A loose node means that other routers can
reside between the source and destination nodes.
Usage Count
The number of LSPs that are either currently using or configured to use the path. For
example, when an LSP named “to_sqa” has primary and secondary paths and both
paths are configured to use the same MPLS path “path_to_sqa,” then the usage
count for “path_to_sqa” would be two (when no other LSP in the system is configured
to use “path_to_sqa”).
The show mpls path wide command allows the user to display the full path name in a single line.
Previously, a long path name (greater than 12 characters) was text-wrapped in multiple lines. Now,
the full path name can be displayed in a single line as shown in the following example.
Brocade(config)# show mpls path wide
Path Name Address Strict/loose Usage
Count
Pathfromsanfranciscotonewyork 10.10.10.2 Strict 1
ppath1
10.10.10.2
Strict
1
spath1
10.20.20.2
Strict
1
Syntax: show mpls path wide
The include option can be used with the show mpls path wide command to filter and display a
specific path.