Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 725)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 701
53-1003031-02
Displaying additional BGP or MPLS VPN information
6
Displaying OSPF interface information
To display OSPF interface information for a specified VRF, enter the following command at any CLI
level.
Brocade# show ip ospf vrf green interface
ethernet 6/3,OSPF enabled
IP Address 192.168.201.1, Area 1
OSPF state DR, Pri 1, Cost 1, Options 2, Type broadcast Events 3
Timers(sec): Transit 1, Retrans 5, Hello 10, Dead 40
DR: Router ID 192.168.201.1 Interface Address 192.168.201.1
BDR: Router ID 1.2.10.2 Interface Address 192.168.201.2
Neighbor Count = 1, Adjacent Neighbor Count= 1
Neighbor: 192.168.201.2
Authentication-Key:None
MD5 Authentication: Key None, Key-Id None, Auth-change-wait-time 300
Syntax: show ip ospf vrf vrf-name interface [ip-addr]
The vrf-name parameter specifies the VRF that the user wants to display OSPF interface
information for.
The ip-addr parameter displays the OSPF interface information for the specified IP address.
Displaying OSPF neighbor information for a VRF
To display OSPF neighbor information for a specified VRF, enter the following command at any CLI
level.
Brocade# show ip ospf vrf green neighbor
Port Address Pri State Neigh Address Neigh ID Ev Opt Cnt
6/3 192.168.201.1 1 FULL/BDR 192.168.201.2 10.2.10.2 6 2 0
Syntax: show ip ospf vrf vrf-name neighbor [router-id ip-addr] | [num] | [detail]
The vrf-name parameter specifies the VRF that the user wants to display OSPF neighbor
information for.
The router-id ip-addr parameter displays only the neighbor entries for the specified router.
The num parameter displays only the entry in the specified index position in the neighbor table. For
example, when the user enters “1”, only the first entry in the table is displayed.
The detail parameter displays detailed information about the neighbor routers.
Displaying the routes that have been redistributed into OSPF
The user can display the routes that have been redistributed into OSPF for a VRF. To display the
redistributed routes, enter the following command at any level of the CLI.