Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 285)

Brocade# show mpls bypass-lsp name t100
LSP t100, to 10.1.1.1
From: 10.2.2.2, admin: UP, status: UP
Times primary LSP goes up since enabled: 1
Metric: 0, number of installed aliases: 0 Adaptive
Maximum retries: NONE, no. of retries: 0
Pri. path: NONE, up: no, active: no
Setup priority: 7, hold priority: 0 ReoptimizeTimer: 300
Max rate: 0 kbps, mean rate: 0 kbps, max burst: 0 bytes
Constraint-based routing enabled: yes
Path calculated using constraint-based routing: no
Path calculated using interface constraint: no
Tie breaking: random, hop limit: 0
Active Path attributes:
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 261
53-1003031-02
Displaying the Traffic Engineering database
1
Table 33 describes the fields that are unique to adaptive LSPs. For the descriptions of fields other
than those described in Table 33 , refer to Table 23 .
TABLE 33 Output from the show mpls bypass-lsp name command
Field Description
Adaptive The bypass LSP was configured to be adaptive.
Reoptimizetimer The period in seconds between attempts to automatically optimize the route of the bypass LSP.
Displaying RSVP session information
To display RSVP Session information for a protected LSP.
NOTE
This section provides a brief example of the display from the show mpls rsvp session command. In
the section titled
“Example of MPLS Fast Reroute configuration” , a detailed example of a network is
given, and examples of output from the show mpls rsvp session command are displayed from each
of the routers in the configuration, along with a descriptions of the relevant information in the
displays.
Brocade# show mpls rsvp session name frr_tunnel
Codes: DI:Ingress Detour DT:Transit Detour DM:Merged Detour
DE:Egress Detour RP:Repaired Session
To From St Style Lbl_in Lbl_out LSPname
10.4.4.4 10.1.1.1(DI) Up SE - 1028 frr_tunnel
Time left in seconds (PATH refresh: 1, ttd: 4294621
RESV refresh: 20, ttd: 156)
Tspec: peak 0 kbps rate 1024 kbps size 0 bytes m 20 M 65535
Explicit path hop count: 3
12.1.1.2 (S) -> 18.1.1.2 (S) -> 15.1.1.2 (S)
Received RRO count: 3
Protection codes: P: Local N: Node B: Bandwidth I: InUse
12.1.1.2 -> 18.1.1.2 -> 15.1.1.2
Detour Sent: Number of PLR and Avoid Node ID pair(s): 1
[1]: PLR: 11.1.1.1 Avoid Node: 11.1.1.2
PATH sentto: 12.1.1.2 (e1/3 ) (MD5 OFF)
RESV rcvfrom: 12.1.1.2 (e1/3 ) (MD5 OFF)
To From St Style Lbl_in Lbl_out LSPname
10.4.4.4 10.1.1.1 Up SE - 1029 frr_tunnel
Time left in seconds (PATH refresh: 6, ttd: 146
RESV refresh: 20, ttd: 140)