Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 253)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 229
53-1003031-02
Displaying MPLS and RSVP information
1
Syntax: show mpls statistics vrf vrf-name
The vrf-name variable allows the user to limit the display of VRF statistics to a specific VRF.
Displaying LSP accounting statistics
When the ingress-tunnel-accounting command has been configured, the user can display
accounting statistics for RSVP-signaled LSPs using the commands described in this section.
When an LSP has the protection of a bypass LSP (as described in “MPLS Fast Reroute using facility
backup over a bypass LSP” ), statistics for the protected LSP always is shown under the protected
LSP even when the protected LSP switches over to the backup LSP riding on a bypass LSP. Bypass
LSP is not listed in the output of the show mpls statistics lsp command. Also, when the user
requests statistics and name a bypass LSP, the system generates an error message.
For example, assume that LSP1 and LSP2 are protected LSPs and that BYPASS is the bypass LSP
that protects both LSP1 and LSP2.
Brocade# show mpls statistic lsp BYPASS
Error - cannot find lsp BYPASS
When the bypass LSP is implicit NULL, then statistics are collected for a protected LSP only when
the protected LSP is not implicit NULL.
Displaying LSP accounting statistics
NOTE
The show mpls statistics lsp command displays LSP accounting statistics for single-hop and
multi-hop LSP routes.
To display RSVP-signaled LSP accounting statistics, enter the following command.
Brocade# show mpls statistics lsp
LSP tope4
Tunnel index 0 0 pkt 0 Byte 0 Avg. pps 0 Avg. Bps
LSP 400
Tunnel index 2 0 pkt 0 Byte 0 Avg. pps 0 Avg. Bps
LSP 4000
Tunnel index 3 0 pkt 0 Byte 0 Avg. pps 0 Avg. Bps
LSP tope41
Tunnel index 4 99205408 pkt 11314220016 Byte 84459 pps 9628340 Bps
When the ingress-tunnel-accounting command is enabled on the RSVP tunnel, the show mpls
statistics lsp command displays statistics for LDP over RSVP traffic.
Endpt Out-Pkt The number of packets forwarded to the specified VRF interface.
Tnl Out-Pkt The number of VRF data packets sent to the remote peer over an MPLS
tunnel.
TABLE 17 show mpls statistics VRF parameters (Continued)
This field... Displays...