Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 815)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 791
53-1003031-02
Displaying VPLS auto-discovery information
8
Displaying information about LDP
To display information about LDP, including the router ID and loopback interface in use, enter the
show mpls ldp command.
Brocade(config)# show mpls ldp
Label Distribution Protocol version 1
LSR ID: 10.2.2.2, using Loopback 1 (deleting it will stop LDP)
Hello interval: Link 5 sec, Targeted 15 sec
Hold time value sent in Hellos: Link 15 sec, Targeted 45 sec
Keepalive interval: 6 sec, Hold time multiple: 6 intervals
Field definitions for the show mpls ldp command are in the section “Displaying LDP information” on
page 400.
Syntax: show mpls ldp
Local VC lbl The VC label value locally allocated for this peer for this VPLS instance. Packets
forwarded from the VPLS peer to this device are expected to contain this label.
This is the label that is advertised to the VPLS peer through LDP.
Remote VC lbl The VC label allocated by the VPLS peer and advertised to this device through LDP.
The device applies this label to outbound MPLS packets sent to the VPLS peer.
Local VC MTU The MTU value locally configured for this peer.
Remote VC MTU The MTU value configured for the remove VPLS peer.
CPU-protection Indicates whether CPU protection is enabled (ON) or disabled (OFF) for this VPLS
instance.
Local Switching Indicates whether local switching is enabled or disabled for this VPLS instance.
TABLE 152 Output for the show mpls vpls name command (Continued)
This field... Displays