Displaying local vll extended counters – Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual
Page 592
568
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying Local VLL extended counters
4
Displaying Local VLL extended counters
When extended counters are enabled for a particular Local VLL instance either by default or explicit
configuration, the user can display the number of bytes and packets received and sent on a
particular endpoint or all the endpoints of that Local VLL instance. The counters are displayed
whether or not the per-VLAN, port, and priority-based accounting mode is enabled at the global
configuration level.
When the per-VLAN, port, and priority-based accounting mode is enabled at the global
configuration level, the following output is displayed for the show mpls statistics vll-local
extended-counters command.
Brocade# show mpls statistics vll-local loc8 extended-counters
VLL loc8, VLL-ID 9: Extended Counters (only applicable for G2 modules)
VLAN
Port
RxPkts
TxPkts
RxBytes
TxBytes
94
5/2
4639941
0
1187824896
0
p0
0
0
0
0
p1
0
0
0
0
p2
0
0
0
0
p3
0
0
0
0
p4
4639941
0
1187824896
0
p5
0
0
0
0
p6
0
0
0
0
p7
0
0
0
0
When the per-VLAN, port, and priority-based accounting mode is disabled, the following output is
displayed for the show mpls statistics vll-local extended-counters command.
Brocade# show mpls statistics vll-local loc8 extended-counters
VLL loc8, VLL-ID 9: Extended Counters (only applicable for G2 modules)
VLAN
Port
RxPkts
TxPkts
RxBytes
TxBytes
94
5/2
1175769
0
300996864
0
92
8/2
0 1178559
0 301711104
Syntax: show mpls statistics vll-local [vll-name | vll-id [extended-counters [[vlan vlan-id] [ethernet
port-id]]]]
The vll-name parameter specifies the configured name for a Local VLL instance.
The vll-id parameter specifies the ID of a Local VLL instance.
The extended-counters keyword enables the extended counters for a particular Local VLL instance.
The vlan vlan-id parameter specifies the ID of the configured VLAN.
The ethernet port-id parameter specifies the port ID of the interface for which the user wants to
display the counters.
describes the output parameters of the show mpls statistics vll-local extended-counters
command.