Displaying information for a specific route – Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual

Page 714

Brocade# show ip bgp vrf black routes not-installed-best

Searching for matching routes, use ^C to quit...

Status A:AGGREGATE B:BEST b:NOT-INSTALLED-BEST C:CONFED_EBGP D:DAMPED

E:EBGP H:HISTORY I:IBGP L:LOCAL M:MULTIPATH S:SUPPRESSED F:FILTERED

Route Distinguisher: 4:1

Prefix Next Hop Metric LocPrf Weight Status

1 10.0.0.0/8 192.168.4.106 100 0 BE

AS_PATH: 65001 4355 701 80

690

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide

53-1003031-02

Displaying BGP or MPLS VRF information

Each of the displayed routes is a valid path to its destination, but the Brocade device received
another path from a different source that has a lower administrative distance. The Brocade device
always selects the path with the lowest administrative distance to install in the IP route table.

Syntax: show ip bgp vrf vrf-name routes not-installed-best

For information about the fields in this display, refer to

Table

121

on page

667.

NOTE

To display the routes that the Brocade device has selected as the best routes and installed in the IP
route table, display the IP route table using the show ip route command.

Displaying BGP4 routes whose destinations are unreachable

To display BGP routes for a specified VRF whose destinations are unreachable using any of the
paths in the BGP route table, enter a command such as the following at any level of the CLI.

Brocade# show ip bgp vrf black routes unreachable