Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 249)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 225
53-1003031-02
Displaying MPLS and RSVP information
1
Displaying MPLS statistics
The following sections describe the commands used to gather MPLS statistics.
Displaying MPLS label statistics
To display all of the MPLS traffic statistics by their MPLS label, enter the following command.
Brocade# show mpls statistics label
In-label In-Port(s) In-Packet Count
1024 e3/1 315431
e3/2 349193
e3/3 0
e3/4 0
1025 e3/1 419750
e3/2 0
e3/3 0
e3/4 0
1024 e5/1 - e5/10 364690
e5/11 - e5/20 0
e5/21 - e5/30 0
1025 e5/1 - e5/10 0
e5/11 - e5/20 0
e5/21 - e5/30 0
When applicable, the show mpls statistics label command also displays statistics for LDP over
RSVP traffic as displayed in the following example.
Brocade# show mpls statistics label
In-label In-Port(s) In-Packet Count
1024 e2/1 - e2/2 45454
e2/3 - e2/4 0
1025 e2/1 - e2/2 0
e2/3 - e2/4 454528
1024 e4/1 - e4/20 0
1025 e4/1 - e4/20 0
To display all of the MPLS traffic statistics by their MPLS label for a Brocade NetIron CES or Brocade
NetIron CER device, enter the following command.
Brocade# show mpls statistics label
In-label In-Port(s) In-Bytes Count
1024 e1/1-e1/24 315431
e1/25-e1/48 0
To display all MPLS traffic statistics by their MPLS label that are gathered by the corresponding
network processor that contains a specific port, enter a command such as the following.