Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 73)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 49
53-1003031-02
show mpls lsp detail/extensive
1
show mpls lsp detail/extensive
The show mpls lsp detail command displays detailed information about a specific LSP. The
underflow-limit parameter and the number of consecutive underflows are displayed. The
adjustment-threshold is used from the global table is indicated with the value for current rate.The
show mpls lsp extensive command shows the adjustment event with the previous rate and the
maximum sampled rate.
The sample history for the current adjustment interval is displayed.
Syntax show mpls lsp [detail|extensive]
Parameters None.
Command
modes
This command operates under all modes.
Usage guidelines The sample history for the current adjustment interval is displayed.
Command
output
The show mpls lsp command displays the following information.
Field output Description
Name The name of the LSP. LSPs are displayed in alphabetical order.
To The egress LER for the LSP.
From The LSPs source address, configured with the from command. When a source IP
address has not been specified for the LSP with the from command, and the LSP has
not been enabled, then ‘(n/a)’ is displayed in the ‘From’ field.
admin The administrative state of the LSP. Once the user activates the LSP with the enable
command, the administrative state changes from DOWN to UP.
status The operational state of the LSP. This field indicates whether the LSP has been
established through signaling and is capable of having packets forwarded through it.
When the status of the LSP is DOWN, the reason why the LSP is down is shown in
parentheses. There may be a short period of time after the user enables the LSP that
the administrative state of the LSP is UP, but the status is DOWN. Once the LSP has
been established through signaling, both the administrative state and the status is
UP.
Tunnel interface
(primary path) The path currently selected for this LSP.
Times primary LSP
goes up since enabled The number of times the status of the LSPs primary path has transitioned from
DOWN to UP.
Metric The metric for the LSP, configured with the metric command.
Pri. path The name of the primary path for this LSP and whether the path is currently active.
up Displays if the primary path is UP.
active Displays if the primary path is active.
Setup priority The configured setup priority for the LSP.
hold priority The configured hold priority for the LSP.
Max rate The maximum rate of packets that can go through the LSP (in kbps), set with the
traffic-eng max-rate command.