Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 282)

258 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
53-1003031-02
Displaying the Traffic Engineering database
1
When the user runs the command with the entire session object (destination ip, source ip, tunnel
id), the router locates a session based on these filter. The router ignores in-interface and out
interface filters when applied in addition to these filters since the entire session is described by its
session object.
The filters and their description are provided in the following sections.
Up displays all the RSVP active sessions.
Down displays all the RSVP inactive sessions.
Active displays all the sessions that are actively using either the facility backup or the one-to-one
detour backup LSPs. It also displays the associated protected session.
Inactive displays all the sessions that are not actively using either the facility backup or the
one-to-one detour backup LSPs. It also displays the associated protected session.
Protection-available displays all the sessions that have either facility backup protection (BI)
available or one-to-one detour protection (DI) available. It also displays the associated protected
session.
Protection-unavailable displays all the sessions that are FRR configured but do not have a detour or
a backup LSP. In case of FRR facility backup, when the protected session is the active session, then
there will not be a BI session available. The session is now considered as a session with protection
unavailable.
Displaying information about OSPF-TE LSAs
To display information about OSPF-TE LSAs.
Brocade# show ip ospf database link-state opaque-area
Area ID Type LS ID Adv Rtr Seq(Hex) Age Cksum
0 OpAr 10.0.0.0 10.3.3.3 80000006 1337 0x1a19
Area-opaque TE LSA
1 - router address (len 4): 10.3.3.3
Area ID Type LS ID Adv Rtr Seq(Hex) Age Cksum
0 OpAr 10.0.0.2 10.2.2.2 80000007 1333 0x88f1
Area-opaque TE LSA
2 - link (len 100):
1 - link type (len 1): point-to-point(1)
2 - link ID (len 4): 10.1.1.1
3 - local i/f ip addr (len 4): 10.1.1.2
4 - remote i/f ip addr (len 4): 10.1.1.1
5 - TE metric (len 4):
6 - max BW (len 4): 2372 Mbits/sec
7 - max reservable BW (len 4): 2372 Mbits/sec
8 - unreserved BW (len 32):
Priority 0: 2372 Mbits/sec
Priority 1: 2372 Mbits/sec
Priority 2: 2372 Mbits/sec
Priority 3: 2372 Mbits/sec
Priority 4: 2372 Mbits/sec
Priority 5: 2372 Mbits/sec
Priority 6: 2372 Mbits/sec
Priority 7: 2372 Mbits/sec
9 - color (len 4): 0
Syntax: show ip ospf database link-state opaque-area