Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 717)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 693
53-1003031-02
Displaying additional BGP or MPLS VPN information
6
• “Displaying OSPF sham links”
• “Displaying OSPF trap status for a VRF”
• “Displaying OSPF virtual links for a VRF”
• “Displaying OSPF virtual neighbor information for a VRF”
• “Displaying IP extcommunity list information”
• “Displaying the IP static route table for a VRF”
• “Displaying the static ARP table for a VRF”
• “Displaying TCP connections for a VRF”
• “Displaying MPLS statistics for a VRF”
Displaying VRF information
To display IP Information for a specified VRF, enter the following command at any level of the CLI.
Brocade# show vrf
Total number of VRFs configured: 1
Status Codes - A:active, D:pending deletion, I:inactive
Name Default RD IFL ID vrf|v4|v6 Routes Interfaces
a 1:1 131071 A | A| A 14
Total number of IPv4 unicast route for all non-default VRF is 12
Total number of IPv6 unicast route for all non-default VRF is 2
Brocade# show vrf a
VRF a, default RD 1:1, Table ID 1 IFL ID 131071
Label: (Not Allocated), Label-Switched Mode: OFF
IP Router-Id: 0.0.0.0
No interfaces
No Export VPN route-target communities
No Import VPN route-target communities
No import route-map
No export route-map
Address Family IPv4
Max Routes: 5120
Number of Unicast Routes: 12
No Export VPN route-target communities
No Import VPN route-target communities
Address Family IPv6
Max Routes: 128
Number of Unicast Routes: 2
No Export VPN route-target communities
No Import VPN route-target communities
Syntax: show vrf vrf-name
The vrf-name parameter specifies the VRF that the user wants to display IP information for.