Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 311)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 287
53-1003031-02
Transit LSP statistics
1
The include option can be used with the show mpls bypass-lsp wide command to filter and display
specific bypass LSP name.
Brocade# show mpls bypass-lsp wide | include bypasstunnelfromsanfranciscotonewyork
Admin Oper Tunnel Up/Dn Retry Active
Name To State State Intf Times No. Path
bypasstunnelfromsanfranciscotonewyork 10.3.3.3 UP UP tnl5 1 0
pathfromsanfrancisotonewyourk
Syntax: show mpls bypass-lsp [wide [| include lsp_name]]
The lsp_name variable specifies the name of the LSP the user wants to display.
The following example shows details of an adaptive bypass LSP named t100:
Brocade# show mpls bypass-lsp name t100
LSP t100, to 10.1.1.1
From: 10.2.2.2, admin: UP, status: UP
Times primary LSP goes up since enabled: 1
Metric: 0, number of installed aliases: 0 Adaptive
Maximum retries: NONE, no. of retries: 0
Pri. path: NONE, up: no, active: no
Setup priority: 7, hold priority: 0, ReoptimizeTimer 300
Max rate: 0 kbps, mean rate: 0 kbps, max burst: 0 bytes
Constraint-based routing enabled: yes
Path calculated using constraint-based routing: no
Path calculated using interface constraint: no
Tie breaking: random, hop limit: 0
Active Path attributes:
Bypass LSP in an RSVP session
Use the show mpls rsvp session command to display bypass LSP xmr1-by. This example shows
bypass LSP traversing a LAG, and the BYI field shows this is the bypass ingress.
Brocade# show mpls rsvp sess name xmr1-by
Codes: DI:Ingress Detour DT:Transit Detour DM:Merged Detour
DE:Egress Detour BI:Ingress Backup BM: Merged Backup BE:Egress Backup
RP:Repaired Session BYI: Bypass Ingress
To From State Style Lbl_in Lbl_out LSPname
10.11.11.11 10.55.55.55(BYI) Up SE - 1267 xmr1-by
Tunnel ID: 512, LSP ID: 1
Time left in seconds (PATH refresh: 8, ttd: 148
RESV refresh: 10, ttd: 140)
Tspec: peak 0 kbps rate 0 kbps size 0 bytes m 20 M 65535
Explicit path hop count: 2
10.0.0.13 (S) -> 10.0.0.9 (S)
Received RRO count: 2
Protection codes: P: Local N: Node B: Bandwidth I: InUse
10.0.0.13 -> 10.0.0.9
PATH sentto: 10.0.0.13 (p4/3(Trunk1) ) (MD5 OFF)
RESV rcvfrom: 10.0.0.13 (p4/3(Trunk1) ) (MD5 OFF
)
Syntax: show mpls rsvp sess name name