Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 81)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 57
53-1003031-02
adjustment-threshold
1
adjustment-threshold
To specify the sensitivity of the automatic bandwidth adjustment of an LSP to changes in
bandwidth utilization, use the adjustment-threshold command. This command is used to set the
threshold for when to trigger automatic bandwidth adjustments. When automatic bandwidth
adjustment is configured, bandwidth demand for the current interval is determined and compared
to the LSPs current bandwidth allocation.
The [no] form of the command sets the adjustment threshold to the default value.
Syntax [no] adjustment-threshold use-threshold-table
Parameters use-threshold-table
The use-threshold-table keyword indicates that the template has to use the autobw-threshold
table to determine the threshold.
Command
modes
This command operates in MPLS sub-configuration mode (config-mpls-template-template1,
config-mpls-lsp-lsp1-autobw).
History
Release Command history
Multi-Service NetIron Release 05.6.00 The command was introduced.
Related
commands
None.